- CITIES SKYLINES TMPE CARS STOPPING AT INTERSECTION MOD
- CITIES SKYLINES TMPE CARS STOPPING AT INTERSECTION PLUS
The reason I ask because it could by an “asset” like vehicles from the Workshop causing an adverse effect. The above is taken directly from the guide below I don't use traffic president, but I've heard about it having an 'enter blocked junction' setting, which I'm guessing is for this exact situation. Either space the two intersections farther apart, or combine them into one intersection. Note: These options have a double hyphen at the start instead of a single hyphen, and also have an uppercase letter at the start of the second word. It has something to do with traffic not wanting to block the intersections.
CITIES SKYLINES TMPE CARS STOPPING AT INTERSECTION MOD
To help rule out mod issue you say this happens to cities that you don’t use mods on? In what way did you do this? Did you shut down the mods and assets or did use a command like “-noWorkshop or –disableMods
CITIES SKYLINES TMPE CARS STOPPING AT INTERSECTION PLUS
Plus most often you can zoom in closer on the ones in the profile rather than other sites. When you upload to your profile they can be viewed easily by others as long as the profile is “public” as yours and mine are. You don’t need to go through the trouble of posting your screenshot to third party site. Without see anything I'm guessing its a volume issue. In this short video, is your traffic doing the same sort of thing? This I have noticed has an effect on the highway overall and sometimes it causes what I call confusion to the highway. If they are too sharp of a turn they will slow the traffic trying to leave the highway. So they wait till they find a gap in traffic large enough to enter that lane or they wait till traffic is clear in that lane before entering.Īnother possible issue causing this is your exit ramps. They for reasons choose to lane change at that spot but the traffic in that lane they wish to change to has such heavy traffic that there is too little room “between” vehicles to change lanes. The only time I have seen this outside of a mod causing issues is heavy traffic and vehicles not having the room to lane change. Instead, vehicles traveling in both directions can proceed, including through vehicles and those turning right or left, when a generic traffic signal/stop. When a vehicle stops on the road does it change lanes before continuing on its way? If no then have you tried to remove the piece of highway and pieces on either side and remake them to rule out broken nodes? Signals are enemies of traffic in City Skylines and will create jams, so having a road scheme inside your city with minimal signals is the best way to go. If an automated car lost contact with its dispatcher, it would stop. You wrote that the traffic is “heavy” on the highway. However, use of autonomous vehicles may also redesign cities to the detriment. Anyway, for the cars pulling over, I think the best place to look might be how parking lanes work. It would be nice to see a screenshot of one of the highways with the issue. The end result will be in TMPE, but initial dev might be better suited to a separate mod where we can easily roll out changes to a large audience of beta testers rather than waiting for TMPE release cycle.
0 kommentar(er)
